Behringer EG2080-RW/BK Manuel D’Utilisation
8
EUROGRAND EG2080-
RW/BK
8) Insert the plug of the pedal unit into the PEDALS connector
on the underside of the playing console.
9) Keep turning the supporting screw underneath the pedal
unit until it rests firmly on the floor without pushing the pedal
unit upwards.
unit upwards.
Correct positioning is necessary to avoid damage
to the pedal unit.
to the pedal unit.
10)Use two S5 screws to fasten the headphones hook
to
the underside of the playing console.
3. QUICK START
3.1 Power on/off
The EG2080 is a digital, i.e. electronic, piano. Therefore, mains
power is required to operate the instrument and it has to be
switched on or off. The following section describes how to
connect the unit to the mains.
power is required to operate the instrument and it has to be
switched on or off. The following section describes how to
connect the unit to the mains.
The POWER switch to the left of the keyboard must
be in the „off“ position when you connect the unit
to the mains.
to the mains.
FUSE HOLDER / IEC RECEPTACLE
The EG2080 is connected to the mains using a standard IEC
receptacle. All required safety regulations have been adhered
to. A matching power cable is included with the unit. Blown
fuses must be replaced with a fuse of the same type and rating.
The EG2080 is connected to the mains using a standard IEC
receptacle. All required safety regulations have been adhered
to. A matching power cable is included with the unit. Blown
fuses must be replaced with a fuse of the same type and rating.
1) Connect the power cable supplied with the unit to the
connector provided on the underside of the instrument and
to a wall socket
to a wall socket
2) Press the POWER switch to the left of the keyboard to switch
the instrument on or off. The LED on the front panel lights up
when the EG2080 is ready for operation.
when the EG2080 is ready for operation.
After playing, switch off the unit with the POWER
switch. The POWER LED on the front panel will go
out. Please note: Merely switching the unit off does
not mean that it is fully disconnected from the
mains. If you do not plan to use your piano for a
prolonged period of time, please disconnect it
from the mains by unplugging the power cable
from the wall outlet.
switch. The POWER LED on the front panel will go
out. Please note: Merely switching the unit off does
not mean that it is fully disconnected from the
mains. If you do not plan to use your piano for a
prolonged period of time, please disconnect it
from the mains by unplugging the power cable
from the wall outlet.
3.2 Adjusting the volume
The volume of the built-in loudspeakers and headphones can be
adjusted as follows:
adjusted as follows:
1) Set the MAIN VOLUME control to mid-travel position, between
MIN and MAX.
2) Adjust the volume as desired by moving the control to the
right (up) or left (down).
ATTENTION!
The EG2080 is capable of producing extreme
volumes. Please bear in mind that high sound
pressures not only temporarily affect your sense
of hearing, but can also cause permanent damage.
Be careful to select a suitable volume at all times,
particularly when you are playing with headphones.
volumes. Please bear in mind that high sound
pressures not only temporarily affect your sense
of hearing, but can also cause permanent damage.
Be careful to select a suitable volume at all times,
particularly when you are playing with headphones.
3. QUICK START