Toro 69X-02-XX Manuel D’Utilisation

The  690  Series  Rotary  Sprinkler  is  designed  for  irrigation  of  large  turf  areas  such  as  golf  courses,  parks,
recreational fields and school grounds.

Manufactured from durable, high strength engineering plastic and stainless steel components, the 690 sprinkler
incorporates  many  innovative  and  time  proven  features  for  lasting,  maintenance-free  operation.  Some  of  these
features are listed below.

• Positive Spring Retraction -  Pulls  nozzle  and  cap  down  out  of  the
way of people and turf maintenance equipment.

• Three Nozzle Sizes - Multiple nozzle sizes provide 45.1 to 82.2 GPM
flow and produce watering radii from 78 to 108 feet.

• Long Life Gear Drive - Gear drive mechanism is vacuum-packed with
lubricant and isolated from water stream for long, trouble-free life.

• Valve-In-Head Models -  Permits  head-by-head  control  to  customize
turf  watering  for  various  topography  and  soil  conditions.  Multi-cycle  for
wind or runoff problems, frost control and dew removal without low-head
drainage.  Available  for  hydraulic  normally  open  or  24  Volt  electric
systems.

• Sprinkler Operating Mode - Electric valve-in-head models have three
modes  of  operation;  AUTO,  ON  and  OFF.  Mode  is  set  using  a  selector
tool inserted through the sprinkler body flange.

• Built-in Check Valve - Check-o-matic sprinklers utilize a check valve in
the  sprinkler  base  to  prevent  seepage  from  low  area  heads  after  valve
closure. Check valve will hold up to 35 feet of elevation differential.

• Two-Speed / 60°-120° Models -Provides for more even precipitation.
Runs at half speed in non-overlapping areas.

• Two-Speed / 180° Models  -Provides  for  more  even  precipitation
where only a selected area is covered by an overlap, such as is found on
greens. Runs at half speed in non-overlapping areas.

• Serviceability -All internal parts of the sprinkler are accessible through
the top of the sprinkler body.

• 78 ft. – 108 ft. Radius
• Pop-Up Nozzle and Cap - 

7

⁄

8

in.

• 1

1

⁄

2

in. NPT Female Thread Inlet

• Recommended Operating

Pressure: 60 – 100 PSI

• Maximum Pressure: 150 PSI
• Electric Models:

– Solenoid - 24 VAC 
– Inrush Current - .40 Amps
– Holding Current - .235 Amps

• Dimensions:

– Cap Diameter - 7

1

⁄

2

in.

– Flange Diameter - 10 in.
– Height - 16 in.