ONKYO BR925 Manuel D’Utilisation
62
Setting the Clock
The AccuClock function normally uses the FM station with the strongest signal to set the clock. However, if the clock
cannot be set properly using that station, you can specify which FM station the AccuClock function should use. This
must be an FM station that supports RDS CT (Clock Time) information.
cannot be set properly using that station, you can specify which FM station the AccuClock function should use. This
must be an FM station that supports RDS CT (Clock Time) information.
Setting AccuClock to Use a Specific Station
1
Remote
controller
Press the [TIMER] button.
2
Press [ENTER] with “Clock”
selected.
selected.
3
Use the Up and Down [
q]/[w] but-
tons to select “AccuClock”, and
then press [ENTER].
then press [ENTER].
4
Press [ENTER].
The frequency flashes on the display.
The frequency flashes on the display.
5
Use the Fast Reverse and Fast For-
ward [
ward [
5]/[4] buttons to tune
into the FM station.
Tip:
If you press the [ENTER] button instead of
using the Fast Reverse and Fast Forward
[
If you press the [ENTER] button instead of
using the Fast Reverse and Fast Forward
[
5]/[4] buttons, the CD/HDD
receiver will automatically search for a
suitable station.
The RDS indicator appears when tuned
into a station that supports RDS.
The RDS indicator will flash while the
CD/HDD receiver searches for a station
and light up continuously when a station
is found.
suitable station.
The RDS indicator appears when tuned
into a station that supports RDS.
The RDS indicator will flash while the
CD/HDD receiver searches for a station
and light up continuously when a station
is found.
Timer 2
Timer 1
Clock
C l ock
RDS-CT Station
: FM 87.50MHz
The asterisks indicate that the
AccuClock function is on.
AccuClock function is on.
6
When you’ve selected the station,
press [ENTER].
While the clock is being set, “Wait…”
flashes on the display. It may take a few
minutes to set the clock. When the clock
has been set, the message “Clock
Adjusted” scrolls across the display, then
the day and time are displayed for a
while.
press [ENTER].
While the clock is being set, “Wait…”
flashes on the display. It may take a few
minutes to set the clock. When the clock
has been set, the message “Clock
Adjusted” scrolls across the display, then
the day and time are displayed for a
while.
Notes:
• If the clock is not set correctly, specify
• If the clock is not set correctly, specify
another FM station and try again or set
the clock manually (see page 63).
the clock manually (see page 63).
• The AccuClock function automatically
updates the clock every day. If you don’t
want it to, you can turn off the Accu-
Clock function (see page 23).
want it to, you can turn off the Accu-
Clock function (see page 23).