Manualsbrain.com
  1. Manuels
  2. Marques
  3. Adaptec
  4. MAN-FC2002-001
  5. Manuel D’Utilisation

Adaptec MAN-FC2002-001 Manuel D’Utilisation

Télécharger
Page de 110
Installing and Removing a Power Supply
81
Installing and Removing a Power Supply
The power supplies are located in the rear of the 
enclosure. Follow these procedures to install and remove the 
power supplies.
Installing a Power 
Supply
1
Select the power supply slot into which the power supply is to be 
inserted and remove the carrier blank if there is one installed.
2
Orient the power supply, such that the LEDs are on the top (on 
the right hand side for rack mount systems).
3
Gently slide the power supply into the empty power supply slot.
4
Secure in place using the two fixing screws (torque setting 
0.3Nm).
5
Install the power cables.
Removing a Power 
Supply
1
Turn off the power supply, and remove the power cable.
2
Loosen the two fixing screws.
3
Using the power supply handle, gently slide it out of the 
enclosure.
CAUTION: Immediately replace the power supply carrier or 
install a power supply carrier blank to maintain correct airflow.
Figure 6-3   Power Supply
0
I
Handle
On/Off
Switch
AC
Inlet