Emerson MVME2500 Manuel D’Utilisation

MVME2500 Installation and Use (6806800L01H)

34

The board is designed to operate as an application-specific computer blade or an intelligent I/O 
board/carrier. It can be used in any slot in a VME chassis. Once the board is installed, you are 
ready to connect peripherals and apply power to the board. 

The console settings for the 

MVME2500

 are:



Eight bits per character



One stop bit per character



Parity disabled (no parity)



Baud rate of 9600 baud

Verify that hardware is installed and the power/peripheral cables connected are appropriate 
for your system configuration.

Replace the chassis or system cover, reconnect the chassis to power source, and turn the 
equipment power on.

Product Damage



RJ-45 connectors on modules are either twisted-pair Ethernet (TPE) or E1/T1/J1 
network interfaces. Connecting an E1/T1/J1 line to an Ethernet connector may damage 
your system. 



Make sure that TPE connectors near your working area are clearly marked as network 
connectors.



Verify that the length of an electric cable connected to a TPE bushing does not exceed 
100 meters.



Make sure the TPE bushing of the system is connected only to safety extra low voltage 
circuits (SELV circuits). 



If in doubt, ask your system administrator.