Emerson MVME2500 Manuel D’Utilisation

MVME2500 Installation and Use (6806800L01H)

32

1. Attach an ESD strap to your wrist. Attach the other end of the strap to the chassis as a 

ground. Make sure that it is securely fastened throughout the procedure.

2. Remove the PMC/XMC filler plate from the front panel cut-out.

3. Slide the front bezel of the PMC/XMC into the cut-out from behind. The front bezel of the 

PMC/XMC module will be flushed with the board when the connectors on the module align 
with the mating connectors on the board.

4. Align the mating connectors properly and apply minimal pressure to the PMC/XMC until it 

is seated to the board.

5. Insert the four PMC/XMC mounting screws through the mounting holes on the bottom side 

of the board, and then thread the four mount points on the PMC/XMC. Tighten the screws.

6. Install the board into the appropriate card slot. Make sure that the board is well seated into 

the backplane connectors. Do not damage or bend connector pins.

7. Replace the chassis or system cover.

8.

Reconnect the system to the power source and then turn on the system.

This section describes the recommended procedure for installing the board in a chassis. Read 
all warnings and instructions before installing the board.

The MVME2500 does not support hot swap. Power off the slot or system and make sure that 
the serial ports and switches are properly configured.

When removing the PMC/XMC, hold it by its long side and exert minimal force when pulling 
it from the baseboad to prevent pin damage.