Nvidia N61V Manuel D’Utilisation

- 12 -

 nVIDIA N61P/N61S/N61V                                                                             User's /Manual

    • For a 2-pin jumper, plug the jumper cap on both 

      pins will make it CLOSE (SHORT). Remove the 

      jumper cap, or plug it on either pin (reserved for

      future use) will leave it at OPEN position. 

    • For 3-pin jumper, pin 1~2 or pin 2~3 can be

      shorted by plugging the jumper cap in.

 

    The time to clear the CMOS memory occurs when (a) 

    the CMOS data becomes corrupted, (b) you forgot

    the supervisor or user password preset in the BIOS

    menu, (c) you are unable to boot-up the system 

    because the CPU ratio/clock was incorrectly set in the

    BIOS menu, or (d) whenever there is modification on 

    the CPU or memory modules.

   This header uses a jumper cap to clear the CMOS 

    memory and have it reconfigured to the default 

    values stored in BIOS.

    • Pins 1 and 2 shorted

       (Default): Normal

       operation.

    • Pins 2 and 3 shorted:

       Clear CMOS memory.

    To clear the CMOS memory and load in the default values:

    1. Power off the system.

    2. Set pin 2 and pin 3 shorted by the jumper cap. Wait for a few seconds. Set the jumper

        cap back to its default settings --- pin 1 and pin 2 shorted.

    3. Power on the system.

    4. For incorrect CPU ratio/clock settings in the BIOS, press <Del> key to enter the BIOS

        setup menu right after powering on system.

    5. Set the CPU operating speed back to its default or an appropriate value.

    6. Save and exit the BIOS setup menu.

    Pin 1-2 short: Support power on by keyboard

    Pin 2-3 short: Disabled power on by keyboard     

Normal

(Default)

Clear CMOS

 

 

 

_

   

   

KB_PWR1:

Disabled

(Default)

Enabled