Nvidia N61V Manuel D’Utilisation

- 2 -

 nVIDIA N61P/N61S/N61V                                                                             User's /Manual

     ・ 

         

If you have 2 floppy drives, you can change A to B, or change B to A.

     ・ 

         

During POST, BIOS will determine if the floppy disk drive installed if choose [Enable].

     ・ 

         

This item defines if the keyboard Num Lock key is active when your system is started.

     ・ 

         [

Normal]:           The A20 signal is controlled by keyboard controller or chipset hardware. 

         [Fast]: (default)  The A20 signal is controlled by port 92 or chipset specific method.

     ・ 

         Keystrokes repeat at a rate determined by the keyboard controller. When enabled, the 

         typematic rate and typematic delay can be selected.

     ・ 

         Set the number of times a second to repeat a keystroke when you hold the key down. 

         The settings are: 6, 8, 10, 12, 15, 20, 24, and 30. 

     ・ 

         Set the delay time after the key is held down before is begins to repeat the keystroke. 

         The settings are 250, 500, 750, and 1000.

     ・ 

         This item determines when the system will prompt for password - every time the system 

         boots or only when enters the BIOS setup.

         [Setup]:   The password is required only when accessing the BIOS Setup.

         [System]: The password is required each time the computer boots up.

     ・ 

         This field is used to enable or disable the APIC (Advanced Programmable Interrupt 

         Controller). Due to compliance with PC2004 design guide, the system is able to run in 

         APIC mode. Enabling APIC mode will expand available IRQ resources for the system.

     ・ 

         This item specifies which version of MPS (Multi-Processor Specification) this mainboard 

         will use. Leave this item at its default setting.

     ・ 

         Allow OS2 to be used with >64MB or DRAM. Settings are Non-OS/2 (default) and OS2. 

         Set to OS/2 if using more than 64MB and running OS/2.

     ・ 

         

This item determines to show the full screen logo when booting.

     ・ 

         EPA Logo is the sign at the top of the screen when POST. If you don't want to show this 

         logo, please set "Disabled".