Nvidia N61V Manuel D’Utilisation

- -

 nVIDIA N61P/N61S/N61V                                                                             User's /Manual

• Choose a chassis big enough to install this mainboard.

• As some features for this mainboard are implemented by cabling connectors on the

mainboard to indicators and switches or buttons on the chassis, make sure your chassis 

supports all the features required.

• If there is possibility of adopting some more hard drives, make sure your chassis has 

sufficient power and space for them.

• Most chassis have alternatives for I/O shield located at the rear panel. Make sure the I/O

shield of the chassis matches the I/O port configuration of this mainboard. You can find

an I/O shield specifically designed for this mainboard in its package.

    Most computer chassis have a base with many mounting holes to allow the mainboard to     

    be securely attached, and at the same time, prevent the system from short circuits. There     

    are two ways to attach the mainboard to the 

    chassis base: (1) with studs, or (2) with spacers.

    Basically, the best way to attach the board is with 

    studs. Only if you are unable to do this should you

    attach the board with spacers. Line up the holes on

    the board with the mounting holes on the chassis. 

    If the holes line up and there are screw holes, you

    can attach the board with studs. If the holes line 

    up and there are only slots, you can only attach with

    spacers. Take the tip of the spacers and insert them

    into the slots. After doing this to all the slots, you can slide the board into position aligned 

    with slots. After the board has been positioned, check to make sure everything is OK before 

    putting the chassis back on.

    To install this mainboard:

    1. Locate all the screw holes on the mainboard and the chassis base.

    2. Place all the studs or spacers needed on the chassis base and have them tightened.

    3. Face the mainboard’s I/O ports toward the chassis’s rear panel.

    4. Line up all the mainboard’s screw holes with those studs or spacers on the chassis.

    5. Install the mainboard with screws and have them tightened.

Always power off the computer and unplug the AC power cord before adding or removing     

any peripheral or component. Failing to do so may cause severe damage to your 

mainboard and/or peripherals. Plug in the AC power cord only after you have carefully 

checked everything.

To prevent shorting the PCB circuit, please REMOVE the metal studs or spacers if they are     

already fastened on the chassis base and are without mounting-holes on the mainboard to     

align with.