Emerson ATCA-9305 Manuel D’Utilisation

 Vendor Commands

ATCA-9305 User’s Manual

The Get Hardware Address command reads the hardware address of the IPMC.

Table 7-22:

 

The Set Hardware Address command allows overriding of the hardware address read from 
hardware when the IPMC operates in (Manual) Standalone mode.

Table 7-23:

 

Request Data

4

Bits [7:5] reserved
Bit [4] IPMB Dump Enable

If set to 1, the IPMC provides a trace of IPMB messages that are 
arriving to/going from the IPMC via IPMB-0 or IPMB-L

Bit [3] Payload Logging Enable

If set to 1, the IPMC provides a trace of SIPL activity on the 
Payload interface onto the Serial Debug interface

Bit [2] Alert Logging Enable

If set to 1, the IPMC outputs important alert messages onto the 
Serial Debug interface

Bit [1] Low-level Error Logging Enable

If set to 1, the IPMC outputs low-level error/diagnostic
messages onto the Serial Debug interface

Bit [0] Error Logging Enable

If set to 1, the IPMC outputs error/diagnostic messages onto the 
Serial Debug interface

Response Data

1

Completion Code

2:4

PPS IANA Private Enterprise ID, MS Byte first

0x00400A = 16394 (Pigeon Point Systems)

Request Data

1:3

PPS IANA Private Enterprise ID, MS Byte first

0x00400A = 16394 (Pigeon Point Systems)

Response Data

1

Completion Code

2:4

PPS IANA Private Enterprise ID, MS Byte first

0x00400A = 16394 (Pigeon Point Systems)

5

Hardware Address 

Request Data

1:3

PPS IANA Private Enterprise ID, MS Byte first

0x00400A = 16394 (Pigeon Point Systems)

  (continued)