Emerson ATCA-9305 Manuel D’Utilisation
Management Processor Monitor:
Test Commands
9-20
setenv name value
Removes the environment variable name from the environment.
setenv name
TEST COMMANDS
The commands described in this section perform diagnostic and memory tests.
diags
The diags command runs the Power-on Self-test (POST).
Definition:
diags
mtest
The mtest command performs a simple SDRAM read/write test.
Definition:
mtest [start [end [pattern]]]
um
The um command is a destructive memory test. Press the ‘q’ key to quit this test; the moni-
tor completes running the most recent iteration, and exits to the default prompt after dis-
playing cumulative results for the completed iterations.
tor completes running the most recent iteration, and exits to the default prompt after dis-
playing cumulative results for the completed iterations.
Definition:
um [.b, .w, .l] base_addr [top_addr]
OTHER COMMANDS
This section describes all the remaining commands supported by the ATCA-9305 monitor.
autoscr
The autoscr command runs a script, starting at address addr, from memory.
A valid autoscr header must be present.
A valid autoscr header must be present.
Definition:
autoscr [addr]
base
The base command prints or sets the address offset for memory commands.
Definition:
Displays the address offset for the memory commands.
base
Sets the address offset for the memory commands to off.
base off