Emerson ATCA-9305 Manuel D’Utilisation
Management Processor Monitor:
Other Commands
9-22
help
The help (or ?) command displays the online help. Without arguments, all commands are
displayed with a short usage message for each. To obtain more detailed information for a
specific command, enter the desired command as an argument.
displayed with a short usage message for each. To obtain more detailed information for a
specific command, enter the desired command as an argument.
Definition:
help [command …]
iminfo
The iminfo command displays the header information for an application image that is
loaded into memory at address addr. Verification of the image contents (magic number,
header, and payload checksums) are also performed.
loaded into memory at address addr. Verification of the image contents (magic number,
header, and payload checksums) are also performed.
Definition:
iminfo addr [addr …]
isdram
The isdram command displays the SDRAM configuration information (valid chip values
range from 50 to 57).
range from 50 to 57).
Definition:
isdram addr
loop
The loop command executes an infinite loop on address range.
Definition:
loop [.b, .w, .l] address number_of_objects
memmap
The memmap command displays the board’s memory map layout.
Definition:
memmap
moninit
The moninit command resets the NVRAM and serial number, and writes the monitor to
flash. The ATCA-9305 must be booted from the boot socket for this command to function in
the default state. The proper region of flash memory will be unlocked and erased prior to
copying the monitor software into it.
flash. The ATCA-9305 must be booted from the boot socket for this command to function in
the default state. The proper region of flash memory will be unlocked and erased prior to
copying the monitor software into it.
The command flags, .1 or .2, force the monitor to be programmed to a single (.1) bank of
flash or dual (.2) banks of flash. If the command flags are not used, then moninit checks for
the number of banks of flash. If there are two banks of flash, then moninit automatically
programs both banks for redundancy. Also, the serial number can be obtained from the fru
data if “fru” is used as a parameter.
flash or dual (.2) banks of flash. If the command flags are not used, then moninit checks for
the number of banks of flash. If there are two banks of flash, then moninit automatically
programs both banks for redundancy. Also, the serial number can be obtained from the fru
data if “fru” is used as a parameter.
Definition:
Initialize environment variables and serial number in NVRAM and copy the monitor from the
socket to NOR (soldered) flash.
socket to NOR (soldered) flash.