Emerson ATCA-9305 Manuel D’Utilisation

 Other Commands

ATCA-9305 User’s Manual

moninit[.1, .2] <serial# or “fru”>

Initialize environment variables and serial number in NVRAM but do not update the monitor 
in NOR flash.

moninit[.1, .2] <serial# or “fru”> noburn

Initialize environment variables and serial number in NVRAM and copy the monitor from 
<src_address> into NOR flash.

moninit[.1, .2] <serial# or “fru”> <src_address>

The pci command enumerates the PCI bus. It displays enumeration information about each 
detected device. The pci command allows you to display values for and access the PCI Con-
figuration Space.

Display a short or long list of PCI devices on the bus specified by bus.

pci [bus] [long]

Show the header of PCI device bus.device.function.

pci header b.d.f

Display the PCI configuration space (CFG).

pci display[.b, .w, .l] b.d.f [address] [# of objects]

Modify, read, and keep the CFG address.

pci next[.b, .w, .l] b.d.f address

Modify, automatically increment the CFG address.

pci modify[.b, .w, .l] b.d.f address

Write to the CFG address.

pci write[.b, .w, .l] b.d.f address value

The phy command reads or writes to the contents of the PHY registers. The values changed 
via this command are not persistent and clear after a hard or soft reset. The port options are 
all, eTSEC1, eTSEC2, and base1 and base2 via the switch. “R” reads the register contents at 
the address specified. “W” writes the address value to the register address specified. “A” 
reads the contents of all registers.

phy [port] [R|W|A] (address) (value)

The following is an example of a read from register address 0x1a.

phy eTSEC2 r 0x1a

The following is an example of a write to register address 0x1a where 0 is the data to write.