Emerson ATCA-9305 Manuel D’Utilisation

 ATCA-9305 Setup

ATCA-9305 User’s Manual

There are a total of seven jumper pairs on J9 (pins 11-14 are spare posts). See figure 

 

for the jumper location on the ATCA-9305. Also reference the “Jumper Settings (0x18)” reg-
ister.

Figure 2-6:

A shunt on pins 1-2 selects the 512 KB socketed ROM as the boot device for the MPC8548. 

If the serial ROM configuration jumper is installed (pins 3-4), the ATCA-9305 will not try to 
configure (IGNORE_SROM*) from the MPC8548 serial ROM.

A shunt installed on pins 5-6 disables the boot redirection, see page 7-41 for more informa-
tion.

A shunt on pins 7-8 causes both Cavium CN5860s to boot from their local bus and not boot 
over PCI.

A shunt on pins 9-10, IPMC stand alone mode, allows the board to boot without manage-
ment control.

Installing a shunt on pins 11-12 puts the IPMC controller into programming mode. This is 
only used in the factory to configure the IPMC.

If BOOT shunt is installed (booting from local bus), this shunt determines whether the boot 
is from local flash or socket.  When this BT FLASH shunt is installed, the ATCA-9305 boots 
from flash. Otherwise, it boots from the socket.

ATCA-9305 SETUP

You need the following items to set up and check the operation of the Emerson ATCA-9305:

  ATCA chassis and power supply
  MPC8548 Console cable for EIA-232 port, Emerson part # C0007662-00
  Computer terminal
Save the antistatic bag and box for future shipping or storage.

13 11 9  7  5  3  1

14 12 10  8  6  4  2

B

T

 SK

T

IG R

O

M

REDIR EN

BOO

T

ST

AND

PR

OG

B

T

 FLA

SH