Emerson ATCA-9305 Manuel D’Utilisation
Setup:
ATCA-9305 Setup
2-10
Figure 2-7:
Air Flow Graph
Hot Swap
). This section describes how to insert and extract an ATCA-9305 module
in a typical AdvancedTCA system. (These procedures assume the system is using a shelf
manager.)
manager.)
Note:
The ATCA-9305 Rear Transistion Module (RTM) has its own Hot Swap LED and switch, and it can be Hot
Swapped in/out independently of the front board. If the front board is not present, then the RTM will not be
powered. If the front board is Hot Swapped out, the RTM’s blue LED will illuminate. In either case, the RTM can
be safely removed.
Swapped in/out independently of the front board. If the front board is not present, then the RTM will not be
powered. If the front board is Hot Swapped out, the RTM’s blue LED will illuminate. In either case, the RTM can
be safely removed.