Emerson 752I Manuel D’Utilisation
Monitor:
Other Commands
15-24
isdram
The isdram command displays the SDRAM configuration information (valid chip values
range from 50 to 57).
range from 50 to 57).
Definition:
isdram
loop
The loop command executes an infinite loop on address range.
Definition:
loop [.b, .w, .l] address number_of_objects
memmap
The memmap command displays the board’s memory map layout.
Definition:
memmap
moninit
Note:
If you have a socketed PLCC flash device installed and you use the moninit command with the serial# param-
eter, it copies the socketed flash image to the soldered flash device.
eter, it copies the socketed flash image to the soldered flash device.
The moninit command resets the NVRAM and serial number, and it writes the monitor to
Flash. Optional parameters allow you to:
Flash. Optional parameters allow you to:
• specify the serial number
• retrieve the serial number from the FRU device
• specify the source address of a monitor image to copy from
• specify parameters not in the default list
Definition:
moninit [serial#, ‘fru’, ‘cold’] [src] [env: ...]
pci
The pci command enumerates the PCI bus if the Katana®752i is the monarch board. It dis-
plays enumeration information about each detected device. The pci command allows you
to display values for and access the PCI Configuration Space.
plays enumeration information about each detected device. The pci command allows you
to display values for and access the PCI Configuration Space.
Definition:
Display a short or long list of PCI devices on the bus specified by bus.
pci [bus] [long]
Show the header of PCI device bus.device.function.
pci header b.d.f
Display the PCI configuration space (CFG).
pci display[.b, .w, .l] b.d.f [address] [# of objects]