Advantech AIMB-250 Manuel D’Utilisation
AIMB-250 Series
28 AIMB-250 Series User’s Manual
2.2.1.2 Installing the Fan and Heat Sink
•
Insert the copper studs to the screw holes around the CPU socket from the top
through the rear side of the board with screw nuts fastened.
through the rear side of the board with screw nuts fastened.
•
Match and place the CPU fan and heat sink assembly on the top of the CPU and
copper studs. Tighten the screws into the copper studs through washers and the
screw holes around the heat sink.
copper studs. Tighten the screws into the copper studs through washers and the
screw holes around the heat sink.
•
Place the CPU Fan Connector.
Note:
Make sure the CPU fan and heat sink assembly and the CPU top surface
are in total contact to avoid CPU overheating problem that would cause the
system to hang or unstable
system to hang or unstable
2.2.1.3 Removing
CPU
•
Disconnect the CPU fan connector.
•
Remove the CPU fan and heat sink assembly first.
•
Unfasten the copper studs from the board.
•
Unlock the Pentium M processor.
•
Carefully lift up the existing CPU to remove it from the socket.
•
Follow the steps of installing a CPU to change to another one.
Screw hole
Copper Stud
Screw nut
(Rear side)
Washers
Screws
Screws
CPU Fan & heat
sink assembly
sink assembly
CPU fan
connector
connector