Q-Logic 8200 Manuel D’Utilisation

6–iSCSI Noninteractive Commands
-bootcodemode (Set BIOS/UEFI [or FCode] Mode)

6-4

SN0054667-00  C

The -bootcode command updates the boot code image, which should be done 

when QLogic releases a new boot code with bug fixes or enhancements. At the 
prompt, type the name of the file containing the boot code image to upload to the 
adapter.

To update the boot code image, issue the -bootcode command as follows:

-bootcode <hba_port_inst> <Bootcode Code Image File Name>

To set the boot code mode for QLA4050, QLA4050C, QLE4060C, QLE4062, and 
QMC4052 adapters, issue the -bootcodemode command as follows:

-bootcodemode <hba_port_inst> <1>|<2>|<3>

Where:

If adapter DHCP is enabled (see 

), 

modes 1–3 are allowed. If adapter DHCP is not enabled, boot code DHCP is not 
allowed. This mode is not supported for QLA4010 adapters. This mode is not 
active for the PPC.

For IBM cards, the following modes are available:

To view the configured settings for the port, issue the -c command as follows: 

-c [hba_port_inst]

When you specify a port instance, information for only that adapter is shown. 
When you do not specify a port instance, information for all adapter ports in the 
system is shown.

1 = Disabled
2 = Manual mode
3 = DHCP–Root path

4 = DHCP vendor ID
5 = DHCP-auto
6 = Auto
7 = System mode

Boot code DHCP is not allowed for QLA4010 adapters.