Emerson MVME55006E Manuel D’Utilisation
MVME55006E Single-Board Computer Installation and Use (6806800A37D)
Hardware Preparation and Installation
Connection to Peripherals
34
5. Slide the MVME5500 into the chassis until resistance is felt.
6. Simultaneously move the injector/ejector levers in an inward direction.
7. Verify that the MVME5500 is properly seated and secure it to the chassis using the
two screws located adjacent to the injector/ejector levers.
8. Connect the appropriate cables to the MVME5500.
1.9.1
Connection to Peripherals
When the MVME5500 is installed in a chassis, you are ready to connect peripherals and apply
power to the board.
power to the board.
shows the locations of the various connectors while
lists them
for the pin assignments of the
connectors listed below.
If a PMC module is plugged into PMC slot 1, the memory mezzanine card cannot be used
because the PMC module covers the memory mezzanine connector.
because the PMC module covers the memory mezzanine connector.
Figure 1-17 Installation into a Typical VME Chassis
Table 1-3 MVME5500 Connectors
Connector
Function
J1
COM1 front-panel connector
J2
Dual 1000/100/10BaseT front-panel connectors
J3
IPMC connector
J4
PCI/PMC expansion connector
J5
CPU COP connector
J11, J12, J13, J14
PMC 1 connectors