Emerson MVME55006E Manuel D’Utilisation

Verify that hardware is installed and the power/peripheral cables connected are appropriate for 
your system configuration.

Replace the chassis or system cover, reconnect the system to the AC or DC power source, and 
turn the equipment power on.

This section gives you information about:

z

The power-up procedure

z

Switches and indicators

After you verify that all necessary hardware preparation is complete and all connections are 
made correctly, you can apply power to the system.

When you are ready to apply power to the MVME5500:

z

Verify that the chassis power supply voltage setting matches the voltage present in the 
country of use (if the power supply in your system is not auto-sensing)

z

On powering up, the MVME5500 brings up the MotLoad prompt, MVME5500>

The MVME5500 board provides a single push button switch that provides both Abort and Reset 
(ABT/RST) functions. When the switch is depressed for less than three seconds, an abort 
interrupt is generated to the processor. If the switch is held for more than three seconds, a 
board hard reset is generated.

J18

Boundary scan connector

J21, J22, J23, J24

PMC 2 connectors

J33

COM2 planar connector

P1, P2

VME rear panel connectors

P4

Memory expansion connector