Omega Vehicle Security 1500 Manuel D’Utilisation

1-2    Configuring and Starting NetScan

NetScan User’s Manual

Depending on your order, your NetScan unit may not require all the steps under this heading.  If a step does
not apply to your unit, simply go on to the next one.

Based on your order, your NetScan system was set at the voltage indicated on the sticker (located on the
rear of the unit, near the power switch).  Verify that the voltage value indicated on the sticker matches the
voltage of your intended AC power supply.  If you need to change the voltage selection for any reason, refer
to Chapter 7’s section entitled, Power Aspects, Changing the Voltage Setting.

The DIP switch is located on the lower right corner of NetScan’s rear panel.  Default settings are as follows.
Note that micro-switch #1 must be set to the “0” position.  The IEEE position does not apply to NetScan.

COMM SELECT

HANDSHAKE (H/S)

PARITY

BAUD RATE

RS-232/422 SELECT

1

2,3

4,5

6,7,8

9

0 – Required for NetScan

1,0 – Hardware Handshake

0,0 – No Parity

1,1,0 – 19200 Baud

0 – RS-232 position

The IEEE position does not apply to NetScan.