Nortel Networks R2MFC Manuel D’Utilisation

Chapter 4 Installing the R2MFC MBM 35

R2MFC Media Bay Module Installation and Configuration Guide

Perform the following steps to install an R2MFC MBM in the BCM expansion unit chassis. Install 
the R2MFC MBM when the system is powered down:  

1 Ensure that both the faceplate and underside DIP switches on the R2MFC MBM are set 

correctly. For information on how to set the faceplate switches, refer to 

. For information about how to set the underside switches, refer to the 

BCM Installation and Maintenance guide for the host system. 

2 Remove the front bezel from the expansion unit.

3 Select an open media bay.

4 With the faceplate of the R2MFC MBM facing toward you, insert the R2MFC MBM into the 

open bay. Ensure that any cables at the rear of the module are clear of the platform base 
chassis.

5 Push the R2MFC MBM into the unit. You will hear a click when the module is firmly seated in 

the media bay.

6 Install the front bezel on the expansion unit.

Caution: Only install the R2MFC MBM when the system is powered down. See 

Warning: Failure to follow procedures to properly disconnect the BCM and 
expansion unit can result in module or system damage.