Nortel Networks Option 11C Mini Manuel D’Utilisation
Page 210 of 332
Chapter 16 — Starting the Option 11C Mini and installing software
553-3021-209
Standard 3.00
April 2000
Start-up procedures
Procedure 27
Start-up procedure for a new system installation, using the MSC card
Start-up procedure for a new system installation, using the MSC card
1
Test the power outlet. Make sure that the correct voltage of power is
present before you plug the power cord into the outlet. The source
must match the label on the back of the chassis.
present before you plug the power cord into the outlet. The source
must match the label on the back of the chassis.
2
Connect the power cord from the power connector on the back of the
chassis to an AC power source. See Figure 63. Secure the power
cable with a cable tie.
chassis to an AC power source. See Figure 63. Secure the power
cable with a cable tie.
Figure 63
Power connector on the back of the chassis
Power connector on the back of the chassis
3
Turn the power switch to “ON”.
4
Observe the TTY or terminal screen. The TTY must be connected to
TTY port 0.
TTY port 0.
5
When you have completed the software installation (see “Installing
software in a new system” on page 215), observe the screen again.
software in a new system” on page 215), observe the screen again.
Power cord
Cable tie