Nortel Networks 4050 Manuel D’Utilisation
734 Chapter 14 Maintaining and managing the system
320818-A
Managing software for a Nortel SNAS 4050 device using
the CLI
the CLI
To view, download, and activate software versions for the Nortel SNAS 4050
device to which you are connected, use the following command:
device to which you are connected, use the following command:
/boot/software
The Software Management menu displays.
reboot
Reboots the Nortel SNAS 4050 device to which you are
connected (using Telnet, SSH, or a console
connection). If you have a Telnet or SSH connection to
the Management IP address (MIP), use the
connected (using Telnet, SSH, or a console
connection). If you have a Telnet or SSH connection to
the Management IP address (MIP), use the
/cfg/sys/host #/reboot
command instead
(see
).
delete
Resets the Nortel SNAS 4050 device to which you are
connected (using Telnet, SSH, or a console
connection) to its factory default configuration. All IP
configuration is lost. The software itself remains intact.
After executing the
connected (using Telnet, SSH, or a console
connection) to its factory default configuration. All IP
configuration is lost. The software itself remains intact.
After executing the
delete
command, you can only
access the device using a console connection. Log on
as the Admin user (user name: admin, password:
admin) to enter the Setup menu.
as the Admin user (user name: admin, password:
admin) to enter the Setup menu.
Note: If you receive a warning that the device you are
trying to delete has no contact with any other master
Nortel SNAS 4050 device in the cluster, also connect to
the MIP (using Telnet or SSH) and delete the Nortel
SNAS 4050 device from the cluster by using the
trying to delete has no contact with any other master
Nortel SNAS 4050 device in the cluster, also connect to
the MIP (using Telnet or SSH) and delete the Nortel
SNAS 4050 device from the cluster by using the
/cfg/sys/host #/delete
command (see
The
/boot/delete
command is primarily intended
for when you want to delete a Nortel SNAS 4050
device in one of the following situations :
device in one of the following situations :
•
The device has become isolated from the cluster,
•
The device has been physically removed from the
cluster without first performing the
cluster without first performing the
/cfg/sys/host #/delete
command.
In these situations, you must use the
/boot/delete
command to present the Setup menu, from which you
can perform the
can perform the
new
and
join
commands.
/boot
followed by: