GE 23954 Manuel D’Utilisation
2.2.2 Network command group
The network command group allows to configure the board for communication over the network.
Command Parameters
Description
showip
Show the current network settings
arp
Show ARP table
manual | dhcp | bootp
Define the network settings at boot-up (*)
manual static IP configuration, the device configuration
(ref.
manual static IP configuration, the device configuration
(ref.
setip) is used
dhcp
network settings retrieved from DHCP server
bootp network settings retrieved from BOOTP server
boot-method
setip
[address]
[netmask]
[gateway]
[netmask]
[gateway]
Set static IP/mask/default gateway
[address] IP-address
[netmask] Subnet
[address] IP-address
[netmask] Subnet
mask
[gateway] Default gateway IP-address
NOTE: network settings can be specified manually only
when boot-method is set to manual
NOTE: network settings can be specified manually only
when boot-method is set to manual
hostname
[hostname]
Define the full qualified domain name
[hostname]
[hostname]
Full qualified domain name
dhcphost
on | off
Get the hostname from DHCP server
NOTE: This functionality is disabled (off) by default
NOTE: This functionality is disabled (off) by default
As most network devices, SNMP/Web adapters use an auto-
negotiation protocol to communicate what media
technologies they support, and then select the fastest
mutually supported media technology.
negotiation protocol to communicate what media
technologies they support, and then select the fastest
mutually supported media technology.
recheck
mii-tool
Running this command shows the negotiated media.
As most network devices, SNMP/Web adapters use an auto-
negotiation protocol to communicate what media
technologies they support, and then select the fastest
mutually supported media technology.
negotiation protocol to communicate what media
technologies they support, and then select the fastest
mutually supported media technology.
auto |
100baseTx-FD |
100baseTx-HD |
10baseT-FD |
10baseT-HD
100baseTx-FD |
100baseTx-HD |
10baseT-FD |
10baseT-HD
speedduplex
Some passive devices, such as single-speed hubs, are
unable to auto-negotiate. To handle such devices, the
SNMP/Web adapter can be forced to operate in one mode,
instead of auto-negotiating.
unable to auto-negotiate. To handle such devices, the
SNMP/Web adapter can be forced to operate in one mode,
instead of auto-negotiating.
Quick network configuration menu
menu
Running this command lunches an interactive menu –
follow the on-screen instructions
follow the on-screen instructions
(*) NOTE: Network settings become effective only after a reboot. Therefore, if these settings must be
modified, the following actions shall be performed in sequence:
• Update the settings, using the applicable command
• Save the settings – nvsave command. Always remember that unsaved setting are lost in case
• Save the settings – nvsave command. Always remember that unsaved setting are lost in case
of reset / reboot
• Reboot the card – reboot command
Modifications reserved
Page 15/58
OPM_CNT_SNM_BAS_CRD_1GB_V012.doc
Operating Manual SNMP/Web Adapter