TANDBERG IP GW 3500 Manuel D’Utilisation

6

The default setting for the IP GW is to use DHCP to obtain an IP address for Port A. 
You can assign a static IP address if you prefer or if a DHCP server is not available.
If you want the IP address of the IP GW to be assigned by your DHCP server, omit 
this step.

To assign a static IP address, use the following command: 

For example, to assign an address of 192.168.1.2 where the default gateway is at 
192.168.1.1, and there is no DNS server, enter:

To return to using DHCP after setting a static address, use the following 
command:

1

To display the current status of the IP address, enter: 

If you have DHCP enabled on your network and you are allowing the IP GW to 
acquire its address using DHCP, the IP address that has been acquired by 
Ethernet Port A will be shown; if you have assigned a static IP address, that is the 
address that will be shown.

2

Make a note of the IP address. You will use this to access the web interface of the 
unit.

If you do not have a DNS server, use 0.0.0.0 as the DNS server IP 
address.