Emerson FPC Manuel D’Utilisation

Floor pedestals are optional equipment that provide clearance for bottom cable entry or exit for FPC 

units not installed on raised flooring. The pedestals are adjustable over a limited range (approxi-

mately 3-1/2" [89mm]) to allow leveling the FPC and minor adjustments in the unit’s installed height.

1. Insert the pedestal threaded shaft into the pedestal holes in the cabinet base as shown in 

Figures 1 and 2.

2. Adjust the pedestal height by turning the welded nut/shaft assembly into or out of the pedestal 

base as required.

3. Lock the height by tightening the jam nut against the pedestal base.

The pedestal may be anchored to the floor by means of the four holes in the base. Locations of 

floor pedestals are shown in Figures 1 and 2.

Floor pedestals may be reverse-assembled for shipping. Before installation, the pedestals 

should be reassembled as shown in Figure 4. When the pedestal is properly assembled, the 

washer on top of the welded nut provides a bearing surface for the unit’s weight.