Emerson IS-WEB485ADPT Manuel D’Utilisation

Use the Web Server Menu to configure access to the card 

through the Web interface. Consult your network adminis-

trator if needed.

To change any parameters:
1. Choose IP Network Settings from the Main Menu, then Web Server.
2. Select an option to change, then use the following guide to make changes.

To access Web Server settings through the Web interface:

• Click on the Configure tab, then Web in the left panel and finally Edit in the right panel. After 

making changes, click Save.

Select the operation mode of the Web server.
• Disabled - Web server is disabled
• HTTP - Standard Web port, not encrypted
• HTTPS - Standard secure Web port, all communication is encrypted

Web Server listening port number. 
• For HTTP mode (non-encrypted communications), the default port is 80.
• For HTTPS mode (encrypted communications), the default port is 443.

For HTTPS, you must also install a security certificate for Internet Explorer. Refer to the appro-

priate section for your version of Internet Explorer:

• 5.4.2 - Install Security Certificates - Internet Explorer 6 or earlier 
• 5.4.3 - Install Security Certificates - Internet Explorer 7 or later 

When enabled, the entire site is password-protected. (If disabled, all pages are accessible 

without a password except configure and control functions.)

Enable or disable the use of a Web browser to perform configuration and control operations. 

Note: This feature affects configuration and control operations from the Web interface only. If 

disabled, these functions may still be available using other system interfaces.

The interval in seconds (10 to 600 seconds) between automatic updates of dynamic Web 

pages—parametric data and device status in the right panel.
RECOMMENDATION: Consider whether frequent updates will slow down the system. If many 

users will access the device simultaneously, select a larger value to best serve all users. 

Recommended values range from 20 to 60 seconds.

Web Server Menu
----------------
1: Web Server Mode

HTTP (Not Secure)

2: HTTP Transport Port

80

3: Password Protect Site 'disabled'
4: Configuration/Control 'enabled'
5: Refresh Rate

30  seconds

<ESC>: Cancel menu level
Please select a key ?>