Emerson IS-WEB485ADPT Manuel D’Utilisation

To perform Control operations through the Web interface:

• Open the Web interface (if needed, see 3.5 - Open the Web Interface).
• Click on the Control tab, as shown in the following example.

• Control Operations categories appear at bottom left, organized with folder icons and showing 

the available Control functions. Clicking on a category changes the view in the right panel. The 

example above shows the summary page. 
The following guide is a partial list of Control operations—these vary by the type of Liebert unit.

• To perform an operation, click on a Control Operations category at left, then click on the appropri-

ate button in the right panel. The example below shows control operations for two Liebert units.

Prevent any pending commands from being completed.

Temporarily silence an audible alarm that is active. Reset or acknowledge alarms

Turn the Liebert unit On or Off; reboot the unit.

Reset statistics—for example, battery or power statistics

Initiate diagnostic tests on the Liebert unit. 

Change setpoints for the Liebert unit.