Grandstream Networks GXW400x Manuel D’Utilisation
Grandstream Networks, Inc.
GXW-400x User Manual
Page 27 of 31
Firmware 1.0.0.17
Last Updated: 12/2006
Directions For Downloading TFTP Server:
1. Unzip the file and put all of the files under the root directory of the TFTP server.
2. Put the PC running the TFTP server and the GXW–400x in the same LAN segment.
3. Go to File -> Configure -> Security to change the TFTP server's default setting from "Receive
2. Put the PC running the TFTP server and the GXW–400x in the same LAN segment.
3. Go to File -> Configure -> Security to change the TFTP server's default setting from "Receive
Only" to "Transmit Only" for the firmware upgrade.
4. Start the TFTP server, in the phone’s web configuration page.
5. Configure the Firmware Server Path with the IP address of the PC.
6. Update the change and reboot the unit.
5. Configure the Firmware Server Path with the IP address of the PC.
6. Update the change and reboot the unit.
You can also download the free HTTP server from
or just use Microsoft IIS web
R
ESTORE
F
ACTORY
D
EFAULT
S
ETTING
WARNING!
Restoring the Factory Default Setting will DELETE all configuration information of the phone.
Please BACKUP or PRINT out all the settings before you approach to following steps. Grandstream will
not take any responsibility if you lose all the parameters of setting and cannot connect to your VoIP
service provider.
not take any responsibility if you lose all the parameters of setting and cannot connect to your VoIP
service provider.
FACTORY
RESET
The only way to reset default factory settings is to follows these four (4) steps:
1. Unplug the Ethernet cable.
2. Locate a needle-sized hole on the back panel of the gateway unit next to the power
connection.
3. Insert a pin in this hole, and press for about 7 seconds.
4. Take out the pin. All unit settings are restored to factory settings.