Acer 08P4100 Manuel D’Utilisation

UnixWare

Manual No. 775079

6-5

If UnixWare is installed on a Mylex controller, the Mylex Disk Array 
Controller driver for UnixWare is already installed in the system. Simply 
install the new Mylex Disk Array Controller hardware.

☛

If you are installing UnixWare 2.1.2 as a secondary 
controller, please refer to “Installing the Mylex Disk 
Array Controller as the Secondary UnixWare 
Controller with UnixWare 2.1.2” on page 6-8.

If UnixWare is installed on a non-Mylex controller, install the Mylex Disk 
Array Controller driver for UnixWare as follows:

☛

If installing onto a system that is SISL capable and 
using a SISL capable DAC it is recommended to 
disable the SCSI chip driver on the system by entering 
the DCU at the appropriate screen then select 
Software Device Drivers and disable the appropriate 
driver. 

1. Insert the Software Kit UnixWare (dak) driver diskette into the floppy 

diskette drive, please refer to “Creating a Driver Diskette for 
UnixWare” on page 6-3.

2. Type the following (match case exactly as shown):

↵

The new controller driver is installed.

3. Rebuild the Kernel:

↵

4. Reboot the system:

↵