Acer 08P4100 Manuel D’Utilisation
UnixWare
Manual No. 775079
6-7
6
U
N
I
X
W
A
R
E
channel on the first controller. Do not set the SCSI ID
of either CD-ROM drives or tape drives to ID 0.
of either CD-ROM drives or tape drives to ID 0.
2. Initialize all the System drives using the RAID EzAssist Configuration
Utility. Make sure the first System drive is less than 2GB.
☛
Note
If installing onto a system that is SISL capable and
using a SISL capable DAC it is recommended to
disable the SCSI chip driver on the system by entering
the DCU at the appropriate screen then select
Software Device Drivers and disable the appropriate
driver.
using a SISL capable DAC it is recommended to
disable the SCSI chip driver on the system by entering
the DCU at the appropriate screen then select
Software Device Drivers and disable the appropriate
driver.
3. Boot the system from the PTF3256 Boot Diskette.
4. Follow the instructions provided in the UnixWare 2.1.2 Installation
Handbook. The Mylex Disk Array Controller driver for UnixWare is
included on the Software Kit UnixWare (dak) diskette made from the
Software Kit CD-ROM.
included on the Software Kit UnixWare (dak) diskette made from the
Software Kit CD-ROM.
• During the installation, you will be prompted to either Install Host
Bus Adapter Drivers or Continue Installation.
• Select Install Host Bus Adapter Drivers,
• Insert the Software Kit UnixWare (dak) driver diskette as instructed,
and continue with the instructions provided in the UnixWare
Installation Handbook.
Installation Handbook.
• The controller should be detected automatically during the install
process.
5. Insert the PTF3256 Supplemental Diskette when prompted.
6. After the installation of boot files, the system is automatically shut
down.
Use /dev/rct0 and /dev/cdrom/c0b0txl0 (x is the CD-ROM SCSI ID
number) to access tape and CD-ROM devices after installation.
number) to access tape and CD-ROM devices after installation.