ADC MM701G2 Manuel D’Utilisation

Chapter 7: Implementing a Point-to-Point LAN Extension

7-3

You are now finished with the Quick Installation. To verify connectivity, refer to 

If you implement custom configuration where you do not use factory default parameters for your modems, you will 
need to make changes to the configuration on both the Remote and the Central-Office modem. The following 
sections provide configuration changes for the Remote modem and then for the Central-Office modem.

To configure the remote modem, you need to change the following settings:

• Operating mode for the modem, (see 

)

• WAN parameters, (see 

• LAN parameters, (see 

Configure the Remote Operating Mode

2

In the IP address box, enter 10.0.0.2.

3

Click Apply to activate the changes. The connection to the Web interface will be lost because the modem 
now has a new LAN IP address.

4

In the Web browser address field (see 

), specify 

http://10.0.0.2 to reconnect.

5

Click Save Changes on the menu bar to prevent losing the configuration after restoring communication 
with the modem.

1

Select DSL on the menu bar then select Advance Configuration under DSL Options.

2

In the Operating Mode box, select Remote to configure the modem for this mode.

3

Click Apply.

 Any device (such as a PC) connecting to the modem LAN interface loses its connection 

when the modem LAN IP address is changed. After the IP address is changed, you need to 
specify this new address in the Web browser to reconnect a device.