ADC SG-1 Manuel D’Utilisation

7-18

Using the no pppoa enable command

The no pppoa enable interface command disables PPPoA negotiation for a specific interface in the system.

Usage

No pppoa enable interface <slot number>\<port number\[sub-interface number]>

For parameters see 

.

The interface atm command defines the atm interfaces in the system.

• The command is accessible at the "configure terminal" menu.

• The command is only applicable with the SCC-ATM155 card.

• When MTU is configured to 1500, the write terminal command should not be used.

• IP address and loopback are not enabled for the PPP interface type.

• The routed type interface does not support unnumbered links.

Usage

interface atm <slot>\<port number>\<sub-interface number> [type <ppp point-to-mul-

tipoint |

routed point-to-point <ip <ip address> <mask> > |

routed-bridge <point-to-point> <ip <ip address> <mask> > | loopback <loopback inter-

face number>

routed-bridge-ppp <point-to-point> <ip [ip address> <mask> > | loopback <loopback 

interface number>

[mtu <1500 | 1544>]