ADC Campus-REX RS Interface Card Manuel D’Utilisation
Configuring with an ASCII Terminal
5-8
Campus-REX RS Interface Card User Manual
2
Type
then press
. The SNMP Configuration menu displays.
3
Continue with the following sections to enter the required parameters
and, if desired, enable authentication error trap generation.
and, if desired, enable authentication error trap generation.
Entering Required SNMP Parameters
To set the required parameters:
1
From the SNMP Configuration menu, type
then press
. The
system prompts you to enter the Read Only Comm String.
2
Type Public, or another string of up to 32 characters then press
.
The SNMP Configuration menu displays.
3
Type
then press
. The system prompts you to enter the Read
Write Comm String.
4
Type Private, or another string of up to 32 characters as prompted then
press
press
. The SNMP Configuration menu displays.
2
ENTER
May 3, 1999
ADC DSL SYSTEMS INC., CAMPUS RS, Version x.xx
13:18:03
Local Unit ID:
Campus-REX Unit #34
Local I/F:
REX
Remote Unit ID: Campus-REX Unit #12
Remote I/F: REX
Circuit ID:
Network Extension Circuit 5001
SNMP CONFIGURATION
1) SNMP Read Only Community String:
public
2) SNMP Read/Write Community String:
private
3) Authentication Trap Status:
Disabled
(Disabled, Enabled)
4) Trap Receiver 1 IP Address:
0.0.0.0
5) Trap Receiver 1 Community String:
public
6) Trap Receiver 2 IP Address:
0.0.0.0
7) Trap Receiver 2 Community String:
public
(R)eturn
ENTER CHOICE>
1
ENTER
ENTER
2
ENTER
ENTER
CAD1069i5.book Page 8 Thursday, May 30, 2002 7:32 AM