MicroNet Technology SP5052 Manuel D’Utilisation

Page de 61
 
 
36
-rtptype 
configure TOS type of RTP packets from 0 to 7       
-rtcptype 
configure TOS type of RTCP packets from 0 to 7 
-sigdelay 
configure signaling packets as normal delay or low delay 
-rtpdelay 
configure RTP packets as normal delay or low delay 
-rtcpdelay 
configure RTCP packets as normal delay or low delay 
-sigthruput  configure signaling packets as normal throughput or high 
throughput 
-rtpthruput  configure RTP packets as normal throughput or high throughput 
-rtcpthruput  configure RTCP packets as normal throughput or high 
throughput 
-sigreliab 
configure signaling packets as normal reliability or high reliability 
-rtpreliab 
configure RTP packets as normal reliability or high reliability 
-rtcpreliab 
configure RTCP packets as normal reliability or high reliability 
 
 
Note:  
Users should be aware that TOS is effective only when network devices (for 
ex: router, switch.. etc.) support TOS. 
 
5.18 [tone] command 
 
Tone of VoIP FXO gateway is configurable if the bureau line is connected to 
PABX or PSTN. Users can refer to “greetrd” command for tone recording and 
analysis. Sometimes the frequencies might shift from standard level. In such a 
situation, users have to adjust the tone value manually using this command. 
 
usr/config$ tone 
 
Setup of call progress tones 
Usage: 
tone -toneX LowFreq HighFreq LowFreqLevel HighFreqLevel TOn1 TOff1 
TOn2 TOff2 
tone -print 
Note: 
 
toneX has the following possibility: 
 
busy1 busy2 reorder1 reorder2 ringtone1 ringtone2 dialtone 
Example: 
 
tone -busy1 400 0 8 0 50 50 0 0 
 
tone -dialtone 400 0 19 0 25 25 0 0 
 
 
5.19 [support] command 
 
This command provides some extra functions that might be needed by users. 
 
usr/config$ support 
 
Special Voice function support manipulation 
Usage: 
support[-tunnel enable] 
support -print