Sony NSP-100 Manuel D’Utilisation

NSP 100

Op
er

at

io

n

System Administrator Setup

21

The “RS-232C Setup” screen appears.

To return to the “System Administrator Setup” 
screen
Carry out any of the following.
• Press numeric button 1, then press the ENTER 

button.

• Using  the  v and V buttons, select “1. Back to 

System Administrator Setup,” and press the 
ENTER button.

Carry out any of the following.
• Press numeric button 2, then press the ENTER 

button.

• Using  the  v and V buttons, select “2. Control,” 

and press the ENTER button.

The setting can now be changed.

Using the b and B buttons, select the desired 
setting, and press the ENTER button.
• When anything other than “Plasma Control” is 

selected, the setting is confirmed.

• When “Plasma Control” is selected, continue to 

step 

.

Using the b and B buttons, select the plasma 
display to be controlled, and press the ENTER 
button.

This confirms the setting.

Carry out any of the following operations.
• Press the MENU button.

• Press numeric button 1, or using the v and V buttons, 

select “1. Back to System Administrator Setup,” and 
press the ENTER button.

To enable the new RS-232C settings, a message prompt 
appears, asking if you want to reset the unit. 

To reset immediately, select “Yes”; to reset later, select 
“No.”

The initial screen or “System Administrator Setup” 
screen appears after a reset (for “Yes”) or immediately 
(for “No”).

You can select Japanese or English as the menu 
language.

Use the following procedure.

In the “System Administrator Setup” screen, carry 
out any of the following.
• Press numeric button 4, then press the ENTER 

button.

• Using  the  v and V buttons, select “4. Menu 

Language,” and press the ENTER button.

The setting can now be changed.

Using the b and B buttons, select “Japanese” or 
“English” as the menu language.

Press the ENTER button.