Emerson 4620 Manuel D’Utilisation

As previously mentioned, it depends on the ATCA-F120 release if the HPI-B daemon files are 
preinstalled or not. If they are not preinstalled or if you want to upgrade existing HPI-B files, you 
need to obtain the desired RPM files and install them manually as follows. 

In order to install/upgrade the HPI-B daemon files on an ATCA-F120 blade, proceed as follows. 

1. Connect to the ATCA-F120 blade where you wish to install the HPI-B daemon files. 

2. Copy the RPM file to the ATCA-F120. 

3. If applicable, enter rpm -e <Old HPI-B daemon package name>  to uninstall 

existing daemon files

4. If applicable, enter rpm -e <Old HPI-B client base package name>  to 

uninstall an installed HPI-B client base package

5. Enter rpm -i <New HPI-B client base package RPM>  

This installs the new HPI-B client base package files. 

6. Enter rpm -i <New HPI-B daemon RPM>  

This installs the new daemon files. 

The following table lists all HPI-B related directories available on the ATCA-F120 after the 
installation. 

At start-up, the HPI daemon reads the following configuration file: 
/opt/motorola/etc/bbs-hpib/bbs-hpib.conf

. 

The only entry which you must configure manually once is the IP address and port used to 
access the SAMs in the Centellis 4620. Both SAMs have a virtual IP address assigned to them 
which is to be used specifically for RMCP-based accesses. This is the IP address which you 
must specify in the configuration file.    

/opt/motorola/bin

Contains HPI-B daemon binaries and compiled client 
example applications. 

/opt/motorola/etc/bbs-hpib

Contains configuration files used to configure the HPI-B 
daemon and clients. See 

 for details on configuring the HPI daemon.   

/etc/init.d

Daemon start/stop script

/opt/motorola/lib

Shared libraries