RAD Data comm ASMi-52 Manuel D’Utilisation

ASMi-52 Ver. 2.5 

Configuring ASMi-52 

1 

Installation of ASMi-52 should be carried out only by an experienced technician. If 
you are familiar with ASMi-52, use this guide to prepare the units for operation. 

1.  Connect the line to the RJ-45 rear panel connector dedicated SHDSL. 
2.  Connect the DTE to the appropriate rear panel connector. 
3.  Connect the control terminal to the rear panel CONTROL connector. 

•  Connect the AC or DC power to the ASMi-52 modem. 

The unit has no power switch. Operation starts when power is connected 
to the rear panel power connector. 

Configure ASMi-52 to the required operation mode via an ASCII terminal 
connected to the rear panel CONTROL port directly or via a modem link. 

 

To connect the terminal: 
1.  Connect the terminal cable to the CONTROL connector of ASMi-52. 
2.  Turn the control terminal on. 
3.  Configure the terminal to the default communication parameters: 9.6 kbps, 

one start bit, eight data bits, no parity, one stop bit. 

4.  Select the full-duplex mode. 
5.  Turn the terminal echo off. 
6.  Disable any type of flow control. 

You are now ready to start a control session.