Quatech ABDB-ET Series Manuel D’Utilisation
FCC Compliance
Page 60
AirborneDirect™ Ethernet Bridge User's Guide
100-8007-141G
Quatech, Inc. Confidential
MANUFACTURER’S DECLARATION OF CONFORMITY
Trade Name:
AirborneDirect™
Serial Bridge
AirborneDirect™
Ethernet Bridge
Airborne Embedded
Radio Module
Model Number:
ABDB-SE-DP101
ABDB-ET-DP101
WLRG-RA-DP101
Compliance Test
Report Number:
Report Number:
B31211D3 F4AWLNG1
Compliance Test
Report Date:
Report Date:
December 11, 2003
July 17, 2006
Responsible Party
(in USA):
(in USA):
Quatech, Inc.
Address:
5675 Hudson Industrial Parkway
Hudson, Ohio 44236 USA
Telephone Number:
(330) 655-9000
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If the unit does cause harmful interference to radio or television reception, please refer to your
user’s manual for instructions on correcting the problem.
INDUSTRY CANADA NOTICE (APPLICABLE TO USE WITHIN
CANADA)
CANADA)
This device complies with Canadian RSS-210.
To prevent radio interference to the licensed service, this device is intended to be operated
indoors and away from windows to provide maximum shielding. Equipment (or its transmit
antenna) that is installed outdoors is subject to licensing.
The installer of this radio equipment must ensure that the antenna is located or pointed such
that it does not emit RF field in excess of Health Canada limits for the general population;
consult Safety Code 6, obtainable from Health Canada’s web site:
To prevent radio interference to the licensed service, this device is intended to be operated
indoors and away from windows to provide maximum shielding. Equipment (or its transmit
antenna) that is installed outdoors is subject to licensing.
The installer of this radio equipment must ensure that the antenna is located or pointed such
that it does not emit RF field in excess of Health Canada limits for the general population;
consult Safety Code 6, obtainable from Health Canada’s web site:
www.hc-sc.gc.ca/rpb
.