RAD Data comm IPmux-16 Manuel D’Utilisation
Chapter 1 Introduction
IPmux-16 Installation and Operation Manual
1-12 Functional Description
PDV
t
t
Packets Leaving IPmux-16
Packets Arriving
Figure 1-10. Packet Delay Variation
PDVT (Jitter) Buffer
IPmux-16 is equipped with a Packet DVT (Delay Variation Tolerance) buffer. The
PDVT buffer or jitter buffer is filled by the incoming IP packets and emptied out to
fill the E1/T1 stream. The buffer begins to empty out only after it is half full in order
fill the E1/T1 stream. The buffer begins to empty out only after it is half full in order
to compensate for packet starvation from the Ethernet side. The time it takes for
half of the buffer to empty out is the maximum DVT time. Delay Variation
half of the buffer to empty out is the maximum DVT time. Delay Variation
Tolerance is configurable. The PDVT (jitter) buffer is designed to compensate for
packet delay variation caused by the network.
packet delay variation caused by the network.
It supports a delay variation of up to E1: 32 ms, T1: 24 ms.
➤
To configure jitter buffer depth:
Estimated or Measured PDV introduced by the network + intrinsic PDV
Estimated or Measured PDV introduced by the network + intrinsic PDV
(if it exists) introduced by the module as a result of configuring the
TDM bytes / frame > 48 (see explanation of calculating intrinsic PDV, below).
TDM bytes / frame > 48 (see explanation of calculating intrinsic PDV, below).
Intrinsic PDV
If TDM bytes/frame is greater than 48, there is an intrinsic delay variation (intrinsic
PDV). The intrinsic PDV introduced by the module is a function of n>1 in
TDM bytes/frame configuration as follows:
I.PDV (ms) = ((n – 1) x 1000) / (frames per second × n)
TDM bytes/frame configuration as follows:
I.PDV (ms) = ((n – 1) x 1000) / (frames per second × n)
Where n =
48
e
bytes/fram
TDM
configured
(n=1 – 8).
PDVT Buffer Effect on Delay
The PDVT buffer is on the TDM path. This means that it adds to the total
end-to-end delay (see delay calculation, below).