GE GFK-1004B Manuel D’Utilisation
B
section level 1
figure_ap level 1
table_ap level 1
figure_ap level 1
table_ap level 1
B-1
GFK-1004B
Appendix
B
Communications Ports Characteristics
This appendix describes the Ethernet Interface serial port used to connect to the GSM
and the AUI port used to connect to the network transceiver.
and the AUI port used to connect to the network transceiver.
What this Appendix Contains
Information pertaining to the Serial Port for Local GSM communications
H Serial Port Pinouts
H Serial Cable Diagrams
H Serial Cable Diagrams
Information pertaining to the Attachment Unit Interface (AUI) Port for Ethernet
communications
communications
H AUI Port Pinouts
H AUI Cable Diagram
H Transceiver Unit Description
H AUI Cable Diagram
H Transceiver Unit Description
Serial Port for Local GSM Communications
This section presents the information you need to construct a cable for serial
communications between the Ethernet Interface and the Local GSM or other serial
terminal. Information in this section includes serial port settings, pinouts, and cable
diagrams.
communications between the Ethernet Interface and the Local GSM or other serial
terminal. Information in this section includes serial port settings, pinouts, and cable
diagrams.
Serial Port Settings
The serial port (COM1) must be set to 9600 bps, 8 bits, no parity, and 1 stop bit.
Serial Port Pinouts
The serial port is located on the front edge of the Ethernet Interface. The serial port is a
9-pin D-type female connector that presents an RS–232 DTE Interface. It is used to
connect the Ethernet Interface to the local GEnet System Manager (GSM). Connector
pinouts are shown in Table B-1.
9-pin D-type female connector that presents an RS–232 DTE Interface. It is used to
connect the Ethernet Interface to the local GEnet System Manager (GSM). Connector
pinouts are shown in Table B-1.