Canon WUX400ST Manuel D’Utilisation
Completing Projector Settings
174
Enabling/Disabling
DHCP
> [Network settings] > [Detailed settings
(wired)] >
[DHCP]
You can turn the projector DHCP
function on or off.
function on or off.
Press the OK button to accept your
setting and then press the MENU
button or EXIT button.
setting and then press the MENU
button or EXIT button.
• [Off] is the factory default.
Specifying TCP/IP
Settings
> [Network settings] > [Detailed settings
(wired) ] >
[TCP/IP setting]
Configure the projector TCP/IP
settings.
settings.
When [TCP/IP setting] is selected, the
window shown below appears. Use the
[ ] / [ ] buttons to select the IP
address, then press the OK button.
Next, use the [ ] / [ ] buttons to select
the digit and the [ ] / [ ] buttons to
change the value.
Press the OK button, then set the
subnet mask and gateway address in
the same way. Finally, select [Enter].
window shown below appears. Use the
[ ] / [ ] buttons to select the IP
address, then press the OK button.
Next, use the [ ] / [ ] buttons to select
the digit and the [ ] / [ ] buttons to
change the value.
Press the OK button, then set the
subnet mask and gateway address in
the same way. Finally, select [Enter].
• The factory default settings are as follows.
IP address:
192.168.254.254
Subnet mask:
255.255.255.0
Gateway address: 0.0.0.0
• Settings cannot be made when [DHCP]
(
) is [On].
• If an invalid value is entered, the message
“Invalid entry” appears. If this occurs, enter
a valid value.
a valid value.
Off
Disables the DHCP function. TCP/IP
settings are possible.
settings are possible.
On
Enables the DHCP function. Searches
the DHCP server. Because the IP
address is acquired from the DHCP
server, it is not necessary to enter the
TCP/IP settings (IP address, subnet
mask, gateway address).
the DHCP server. Because the IP
address is acquired from the DHCP
server, it is not necessary to enter the
TCP/IP settings (IP address, subnet
mask, gateway address).