Canon WUX400ST Manuel D’Utilisation

57

Op
er

ation

Pr

oje
ctin

g

 an Imag

e

If the image display is shifted or there is flickering of the screen when [Analog PC-1] 
or [Analog PC-2] is selected, press the AUTO PC button to adjust the projector to 
the optimal condition.
The adjustment results will be stored. If the projector is used again with the same 
computer, when the input signal is selected the image will be projected 
automatically under the same conditions that were previously adjusted.

■ Performing the Auto PC Function

Press the AUTO PC button to perform projector adjustment.

To adjust the image size, turn the lever on the projection lens. Change the projector 
installation position (

) if your desired image is too large or too small to adjust it 

with the zoom function.

If the Auto PC adjustment is insufficient, perform the following operations.
• Select the input signal that matches the resolution of the computer from [Input signal 

select]. (

• If adjustment is insufficient even when using the above operation, adjust [Total dots], 

[Tracking], [Horizontal position], [Vertical position], [Horizontal pixels] and [Vertical 
pixels] in [Input signal settings]. (

)

• For the signal types supported by the projector, see the table on 

Remote control

Projector