Sanyo WM5500L Manuel D’Utilisation

Open the battery 
compartment lid.

Install new batteries into 
the compartment.

Replace the 
compartment lid.

Press the lid downward and 
slide it.

Two AAA size batteries
For correct polarity (+ and 
–), be sure battery terminals 
are in contact with pins in the 
compartment.

To ensure safe operation, please observe the following precautions :
  ●  Use two (2) AAA or LR03 type alkaline batteries.

  ●  Always replace batteries in sets.

  ●  Do not use a new battery with a used battery.

  ●  Avoid contact with water or liquid.

  ●  Do not expose the remote control to moisture or heat.

  ●  Do not drop the remote control.

  ●  If the battery has leaked on the remote control, carefully wipe the case clean and install new 

batteries.

  ●  Risk of an explosion if battery is replaced by an incorrect type. 

  ●  Dispose of used batteries according to the instructions or your local disposal rule or guidelines.

Point the remote control toward the projector (to Infrared Remote 
Receivers) when pressing the buttons. Maximum operating range 
for the remote control is about 16.4’ (5 m) and 60 degrees in front, 
back and top of the projector.

Infrared Remote Receivers are provided in front, back and top of of 
the projector. You can conveniently use all of the receivers (pp. 10, 
11, 59).

16.4’
(5 m)

The remote control can be used as a wired remote control. Wired 
remote control helps you use the remote control outside of the 
operating range (16.4’/ 5 m). Connect the remote control and the 
projector with the remote control cable (sold separately). Connected 
with the remote control cable, the remote control does not emit 
wireless signal.

16.4’
(5 m)



     When hanging the projector from the ceiling, select the Infrared