Sanyo WM5500L Manuel D’Utilisation

The eight different remote control codes (Code 1–Code 8) are assigned to this projector. Switching the remote control 
codes prevents interference from other remote controls when several projectors or video equipment next to each other are 
operated at the same time. Change the remote control code for the projector first before changing that for the remote control. 
See “Remote control” in the Setting Menu on page 58.

Press and hold the MENU and a number button (1–8) for 
more than five seconds to switch between the codes.

To initialize the remote control code, slide the RESET/ ON/
ALL-OFF switch to “RESET”, and then to “ON”.  The initial 
code is set to Code 1.

Press and hold the MENU and a number button 
(1-8) that corresponds to the remote control code 
for more than five seconds to switch between the 
codes. 

Adjustable Feet

Projection angle can be adjusted up to 4.0 degrees with the 
adjustable feet. 

Rotate the adjustable feet and tilt the projector to the proper height; 
to raise the projector, rotate the both feet clockwise.

To lower the projector or to retract the adjustable feet, rotate the 
both feet counterclockwise.

To correct keystone distortion, press the KEYSTONE button on the 
remote control or select Keystone from the menu (see pages 14, 
31, 44, 50).