Sanyo WM5500L Manuel D’Utilisation

Filter counter Reset? 
appears.

Select yes, then another 
confirmation box appears.

Scroll counter Reset? 
appears.

Select yes, then another 
confirmation box appears.

Turn off the projector and unplug the AC power cord. Let the 
projector cool for at least 45 minutes.

Loosen the screw and open the lamp cover. Loosen 3 screws 
of the lamp and pull out the lamp by using the built in handle.

Replace the lamp with a new one. Make sure that the lamp is 
properly and fully inserted. 

Connect the AC power cord to the projector and turn on the 
projector.

Follow these steps to replace the lamp.

Note:

For continued safety, replace with a lamp  of the 
same type. Do not drop the lamp or touch the glass 
bulb! The glass can shatter and may cause injury.

Allow a projector to cool for at least 45 minutes 
before you open the lamp cover. The inside of the 
projector can become very hot.

When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the screen and

 the Lamp replacement icon appears on the screen and

the Lamp replacement icon appears on the screen and 

LAMP REPLACE indicator lights orange. Replace the lamp with a new one promptly. The timing when the LAMP REPLACE 
indicator should light is depending on the lamp mode.

Lamp replacement icon

Note:

Close the lamp cover and secure the screw. 

Lamp

Handle

Lamp cover

Screw

New Lamp

When replacing the lamp because it has stopped illuminating, 
there is a possibility that the lamp may be broken.
If replacing the lamp of a projector which has been installed 
on the ceiling, you should always assume that the lamp is 
broken, and you should stand to the side of the lamp cover, 
not underneath it. Remove the lamp cover gently. Small 
pieces of glass may fall out when the lamp cover is opened.
If pieces of glass get into your eyes or mouth, seek medical 
advice immediately.

Screws