Canon LV-7295 Manuel D'Instructions

66

Filter prevents dust from accumulating on the optical elements inside the projector. Should the Filter become clogged 

with dust particles, it will reduce cooling fans’ effectiveness and may result in internal heat buildup and adversely 

affect the life of the projector.  If a “Filter warning” icon appears on the screen, replace the Filter immediately. 

Replace the filter by following the steps below.

- Do not operate the projector with the filter  

  removed. Dust may accumulate on the optical  

  elements degrading picture quality.

- Do not put anything into the air vents. Doing so 

  may result in malfunction of the projector.

- Do not wash the filter with water or any other  

  liquid Matter. Otherwise the filter may be 

  damaged.

  When using the projector under dusty or 

smoky conditions, dust may accumulate 

on a lens, LCD panels, or optical elements 

inside the projector degrading the quality of a 

projected image.  When the symptoms above 

are noticed, contact your authorized dealer or 

service center for proper cleaning.

Be sure to reset the Filter counter after cleaning or 

replacing the filter. 

Press the MENU button to display the On-Screen 

Menu. Use the Point ▲▼ buttons to select Setting 

and then press the Point ► or the OK button.

Use the Point ▲▼ buttons to select 

Filter counter 

and then press the Point ► or the OK button. Use 

the Point ▲▼buttons to select 

reset and then press the OK button. Filter counter

Reset? appears. Select Yes to continue.

appears.

Select 

Yes, then 

another confirmation 

box appears.

Select 

Yes again 

to reset the Filter 

counter.

Another confirmation dialog box appears, select 

Yes to reset the Filter counter.

Turn off the projector, and unplug the AC power 

cord from the AC outlet.
Place the latch in the OPEN position and pull out 

the filter in the arrow direction.

Slide the new filter (along the guide rails. Make 

sure that the filter is inserted completely.) Place 

the latch back in the LOCK position.

Filter

Latch

Connect the AC power cord to the projector and 

turn on the projector.

Reset the filter counter.

OPEN

LOCK



  • When replacing the 

filter, it is required 

a certain space to 

pull out the filter 

completely.

  • When installing the 

projector, install the 

projector with keeping 

a certain space for 

replacing the filter.