Canon LV-7295 Manuel D'Instructions

68

When the projection lamp of the projector reaches its 

end of life, the Lamp replacement icon appears on the 

screen and LAMP REPLACE indicator lights yellow. 

Replace the lamp with a new one promptly. The timing 

when the LAMP REPLACE indicator should light is 

depending on the lamp mode.

Follow these steps to replace the lamp.

For continued safety, replace with a lamp of the same 

type. Do not drop a lamp or touch a glass bulb! The 

glass can shatter and may cause injury.

Allow a projector to cool for at least one hour 

before you open the Lamp Cover. The inside of the 

projector can become very hot.

Unplug the AC power cord. Let the projector cool 

for at least one hour.

Loosen the three (3) screws that secure the lamp. 

Lift the lamp out of the projector by using the 

handles.

Replace the lamp with a new one and secure the 

three (3) screws. Make sure that the lamp is set 

properly. Close the lamp cover and secure the 

screw.

Loosen the screw and open the lamp cover.

Connect the AC power cord to the projector and 

turn on the projector.

Screw

Handles

Screw

Lamp Cover

Screw

Screw

When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may be broken.

If replacing the lamp of a projector which has been installed on the ceiling, you should always assume that the 

lamp is broken, and you should stand to the side of the lamp cover, not underneath it. Remove the lamp cover 

gently. Small pieces of glass may fall out when the lamp cover is opened. If pieces of glass get into your eyes or 

mouth, seek medical advice immediately.



  • The Lamp replacement icon will not appear when the Display function is set to 

Off (p.53), during 

Freeze (p.8), or Blank (p.9).

OK

POWER

AUTO SET

MENU

LAMP REPLACE

WARNING

VOL

VOL

See "Lamp Counter" on page 6.

Lamp