Toshiba B-SX8T Manuel D’Utilisation
2. SYSTEM MODE
EO13-33002
2.2 Parameter Setting
2-26
After setting the control code for Control Code 1, press the [PAUSE] key to show the CONTROL CODE2
screen. In a same manner, press the [PAUSE] key after setting the control code for Control Code 2 to
display the CONTROL CODE3 screen.
Press the [PAUSE] key after setting the control code for Control Code 3.
screen. In a same manner, press the [PAUSE] key after setting the control code for Control Code 2 to
display the CONTROL CODE3 screen.
Press the [PAUSE] key after setting the control code for Control Code 3.
2.2.13 Ribbon Type Selection
This parameter is to choose a ribbon type to be used.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting a ribbon type, press the [PAUSE] key.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting a ribbon type, press the [PAUSE] key.
2.2.14 Strip Wait Status Selection
This parameter is to choose when the printer sends a strip wait status (05H) to a host in response to a
status request command.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the Strip Wait Status, press the [PAUSE] key.
status request command.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the Strip Wait Status, press the [PAUSE] key.
<2>PARAMETER SET
PEEL OFF STS OFF
PEEL OFF STS OFF
[RESTART]
[FEED]
PEEL OFF STS ON
A strip wait status is sent when the printer receives the next
issue command and the previously printed label is waiting to
be removed.
issue command and the previously printed label is waiting to
be removed.
PEEL OFF STS OFF
A strip wait status is sent when a printed label is waiting to
be removed.
be removed.
<2>PARAMETER SET
RIBBON TRANS
RIBBON TRANS
RIBBON NON TRANS
RIBBON TRANS
[RESTART]
[FEED]
Non transparent ribbon
Transparent ribbon
CONTROL CODE1
CONTROL CODE2
CONTROL CODE3
[PAUSE]
[PAUSE]